kitchen Glass Cabinet Display ideas
kitchen glass cabinet display ideas: To make a glass cabinet like this, both L Hinges and Z Hinges may be required depending on the place. Before installing glass in the kitchen door, the frame of the kitchen cabinet has to be made. Its size is made as per the requirement but the size of the door should always be more than the width. When the entire structure of the cabinet is ready, then the door has to be cut according to the frame and the hinges have to be installed.
After installing the hinges in the door, if the door gets properly set in the cabinet frame, then 2 inch or 2.2 inch should be cut from all the sides of the door and after removing the middle plywood, a strip of 8mm by 8mm wood should be fitted correctly. It is then glued to a 3/4×19 piece when it is finished by applying sarmaika from all sides.
Measurements should be taken from the back side of the door, that too from the inside and after bringing 5mm glass, it has to be pasted with silicon from the back edge. When the work is completed, all the doors have to be fitted.
The depth of this type of cabinet is 9 inches to 11 inches, yet it should be made as per the requirement. The length and width are made according to the world.
Ingredients used in Kitchen Glass Cabinet Display:
- plywood 18 mm – use by Frame Side.
- plywood 8 mm – use by back Side .
- 8×4 Sunmica white in Side .
- 8×4 Sunmica Color out Side .
- 3×1/2×18mm L Highest .
- 3×1/2×18mm plan Hinges .
- 2 No Magnets Door .
- Handle .
- 6 inch chan .
- Fevicol marine .
- Abro tape.
- Silicon .
- 4×13 Screw.
- 6×13 Screw.
- 6×19 Screw.
- 6×25 Screw.
- 8×32 Screw.
- 8×38 Screw.
- 8×50 Screw.
- 8×60 Screw.
- 3/4×19 nail (Nail)
- 14×1.4 nail (Nail)
- 14×2 nail (Nail)
- 1″×1/2″ wood patti.
