Bedroom kapat (wardrobe) design
Bedroom kapat (wardrobe) design: This type of kapat is made in plywood or wood in which clothes and jewellery. Money Documents Document And children’s toys are kept safe. These days, it is very important to have a document because it is the most valuable document. Rupee There is jewelery which has to be taken care of and the door makes it easy to take out the item immediately.
Bedroom cabinet Future: It is very important to make drawers in the kapat (wardrobe)
and locks are also installed in some drawers in which jewelery and documents can be secured. To hang the clothes in the upper part of the wardrobe, 1 inch rod pipe is installed in which a height of 38 inch to 40 inch is left. Drawers are installed in the lower part and then self plates are placed in the lower part. Either self should be kept as per requirement.
L in wardrobe with doors. Z | And plain hinges are installed /
Bad room wardrobe Size: Most of the wardrobe sizes are made according to the space but the depth of the wardrobe with hinges should not be less than 18 inches, otherwise the clothes hanger cannot be hung in the wardrobe.
The height of the door is only 77 inches to 84 inches, if the height is more than that then second doors are made above and the length can be increased according to the space. The door with cover should not be more than 22 inches wide. 18 inches door is the normal size.
But this cannot be done in a siling door because the width should not always be more than the height in a sliding door, otherwise the siling door cannot run properly.
It is necessary to keep the depth of the sliding wardrobe at least 22 inches and a border strip of 1.4 inch by 10 mm is placed on the outer edge and a 16 inch drawer channel is installed in this wardrobe. Self size is up to 18 inches. The middle height plate is 19 inches. Siling door always runs on bearings in which aluminum bottom plates are installed at the top and bottom. In sliding wardrobe, the drawer always remains on the side, due to which it is easy to open the drawer.
Materials used in making doors and wardrobe:
- Plywood 18 mm Frame .
- Plywood 8 mm Back Side .
- Ply bord 25 mm Door .
- 8 by 4 (Liminet) Sunmica .
- Kg Fevicol marine .
- 6 inch Handle .
- 8 inch Handle .
- 2 No Magnets .
- 8 inch Door chain .
- Abro Tape .
- 1 inch SS pipe and Socket .
- 16 inch drawer channel. For 18 inch depth Kapat Door and 22 inch depth Silliding kapat.
- 3× 3/4 ×12 mm Hinges L .25 mm Door.
- 3× 3/4 ×18 mm Hinges L .25 mm Door.
- 3× 3/4 ×6 mm Hinges L .25 mm Door.
- Hinges Plan .
- 3×1/2 ×12 mm Hinges L .18 mm Door.
- 3× 1/2 ×18 mm Hinges L .18 mm Door.
- 3× 1/2 ×6 mm Hinges L .18 mm Door.
- 4×13 Screw.
- 6×13 Screw.
- 6×19 Screw.
- 6×25 Screw.
- 8×32 Screw.
- 8×38 Screw.
- 8×50 Screw.
- 8×60 Screw.
- 3/4×19 Nail (Nail) .
- 2×14 Nail (Nail).
- 1.4×14 Nail (Nail) .
