2 Door sliding wardrobe designs idea
2 Door sliding wardrobe designs :
Sliding door is very good, an experienced craftsman is required to make it.
Sliding door is very easy to operate and sliding doors open easily in less space at their place. Sliding door runs on aluminum channel track and Selling Baring (Roller) is installed on both sides of the door. These Rollers come in many types. The method of fitting of all is almost the same.
The lower track is installed leaving about 10 mm to 12 mm from the edge of the plywood. The upper track is installed leaving about 4 mm from the edge of the plywood.
Before installing the roller, a measurement has to be taken by placing it in the groove of the track pump closer above and leaving 18mm more than that measurement, the roller groove is taken out and the roller is fitted in the same groove. There are 4 rollers for one door 
and According to fitting, grooves are taken out at top and bottom.
Sliding kapat Size: The width of the sliding kapat should always be more than the height / so that the door can move properly. The entire size of the sliding kapat can be made up to 82 inch height by 96 inch width. If the height is taken more then it is possible that the door may not fit properly. Will work / Sliding door height should not be too much
Sliding wardrobe designs: First of all 23 inch or as per requirement plywood is cut for the door, in which top, bottom and 2 side plywood is exactly the same, leave 3.4 inches for two doors. are going. And the middle width-length plate is cut by reducing it by 3.4 inches from the edge of plywood. After this, all the plates are kept at least 2 inches away from the door inside so that the hands do not get hurt while opening the door. Especially the Siliding Cupboard should be made keeping this in mind.
Drower Channel: Size is 16 inches, you can install it up to 18 inches or so as per requirement. Always keep in mind that the drawer should be 1 to 1.4 inches from the back door. These are always fitted with slotted handles which make it easier to open the doors.
Self party: Self is placed on the Self Button. The width of Self is up to 18 inches and cutting is done according to the length inside the cabinet.
2 Door Siding Material List :
- 7×4 ply Board 25 mm use for Door.
- Plywood 18 mm Frame and Self .
- Plywood 8 mm Back side .
- 8×4 Limited (Sunmica) in Side .
- 8×4 Limited (Sunmica) Color out Side .
- Sliding Door Fittings Set .
- Handle 4 inch in Side .
- Handle 8 inch Out Side .
- 16 inch Drower चैनल . use by Kapat .
- Fevicol marine .
- Hitex .
- Abro Tape .
- Wall Pvc Plug .5mm
- 2×14 Khila.
- 1.4×14 Khila.
- 1×17 Khila.
- 3/4×19 Khila.
- 4×13 Screw.
- 6×13 Screw.
- 6×19 Screw.
- 6×25 Screw.
- 8×32 Screw.
- 8×38 Screw.
- 8×50 Screw.
- 8×60 Screw.
- 8×75 Screw.
For Top door and dressing Table
- 14 inch Drower channel .
- 2 No Magnet .
- 4×13 Screw.
- D Brakit For 6 mm Glass .
- L Hinges 3×1/2 × 12 mm .
- L Hinges 3×1/2 × 18 mm .
- 3×1/2 × 3/4 Plane Hinges .
- Door hydraulic pump 20kG .
